![]() Normally with a rachet PVC tubing cutter this may work because it will cut gradually in evenly with the tubing cutter going around and around, but these two conduits are so close to each other there is no room between them. ![]() The other issue is whether plan A or B, I will need to cut the sleeve back. Any recommendation on what kind of box would be best suited for this situation where the box will be right at grade and subject to occasional flooding in south Florida? In that case the new box will sit even lower than the current one. If I cannot find where all the wires go, or if these wires won't pull due to dirt/water sitting in the conduits for ages, then I have to go with a plan B which is to try and cut away the male adapters with the existing wiring in place, then cut back this thick sleeve another inch or so to expose form of the conduit for cementing on new fittings. Round Electrical Splice Box 910 - The Home Depot Protect wire connections for electrical equipment with the 10 in. My plan A is to see if I can find the other end of these wiring, there are five conductors inside each wire nut and so I have to find the other end of all five, open these boxes up and see if I can pull back the wires in them and replace with longer wires, if that's successful then I will need to put in couplings where the two male adapters are and a short piece of PVC conduit to raise new box higher above grade.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |